VLB11SCSFF
550 Line Color Bullet Camera
Focus Free
Wall & Ceiling Mountable
Please read this manual thoroughly before operation and keep
it handy for further reference.
WARNING & CAUTION
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
:
TO REDUCE THE RISK OF ELECTRIC SHOCK
D O N O T R E M O V E C O V E R ( O R B A C K ) .
NO USER SER VICEABLE PART S INSIDE
R E F E R S E R V I C I N G T O Q U A L I F I E D
S E R V I CE PER SONNEL._______________
The lighting flash with an arrowhead symbol, within an equilateral triangle is
Intended to alert the user to the presence of un-insulated “dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons____________________________________
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (serving) instructions
in the literature accompanying the appliance__________________
INFORMATION -This equipment has been tested and found to company with
l i m i t s f o r
These limits are designed to provide reasonable protection against harmful
I nterference W hen the equipments operated in commercial environment.
a
c l a s s
a
d i gi t a l device Pursuant to part 15 of the FCC rules.
a
This equipment generates, uses, and Can Radiate radio frequency energy and
if not installed and used in accordance with the instruction manual, may Cause
Harmful interference to radio communications. Operation of this equipment in
a
r e s i d e n t i a l a r e a i s l i k e l y t o c a u s e h a r m f u l i n t e r f e r e n c e i n w h i c h
Case the user will be required to correct the interference at his own expense.
WARNING – Change or modification not expressly approved by the manufacturer could void
the user’s authority to operate the equipment__________________________________
CAUTION : To prevent electric shock and risk of fire hazards.
DO NOT use power sources other than that specified.______
DO NOT expose this appliance to rain or moisture.000
This installation should be made by a qualified service person and should conform to all local codes.
2
PACKAGE CONTENTS
Please make sure that the following items are included
in the package:
1 VLB11SCSFF Camera
3 Mounting Screws
1 Video test Connector
1 Wrench
Please leave this manual with the end-user for future
reference.
4
PRECAUTIONS
•
•
•
THIS CAMERA SHOULD BE ONLY INSTALLED BY QUALIFIED
PERSONNEL
TO PREVENT A FIRE OR ELECTRICAL HAZARD PLEASE USE
PROPER POWER CABLE
DO NOT CLEAN THE COVER WITH AN ABRAISIVE CLEANING
MATERIAL - PLEASE USE A SOFT CLOTH OR TISSUE TO
CLEAN THE COVER
•
THERE ARE NO USER-SERVICEABLE PARTS INSIDE.
PLEASE DO NOT DISASSEMBLE THIS CAMERA OTHER THAN
TO MAKE INITIAL ADJUSTMENTS
•
•
•
•
PLEASE USE A UL APPROVED REGULATED 12 VOLT DC
POWER SUPPLY
PLEASE USE APPROPRIATE LOW VOLTAGE POWER CABLE
TO PREVENT FIRE OR ELECTRICAL SHOCK
PLEASE INSURE THAT YOUR INSTALLATION AREA CAN
SUPPORT THE WEIGHT OF THE CAMERA
PLEASE HANDLE THIS CAMERA CAREFULLY:
- DON’T USE A STRONG OR ABRASIVE DETERGENT WHEN
CLEANING THE CAMERA.
- DON’T EXPOSE THE CAMERA TO DIRECT SUN
5
CAMERA INSTALLATION
CONNECT POWER CABLE
1. WHEN USING 12 VOLTS DC (constant voltage 500 mA)
Power Input :RED
Center : (+)
DC 12V Power Supply
2. CONNECT VIDEO CABLE
-CONNECT BNC CABLE TO THE BNC JACK.
6
CAMERA INSTALLATION
CONTROL BOARD
2
3
1
1) Video Test Terminal
For second video output
2) OSD (On Screen Display) Joy stick
Press the Joy stick for one second until the OSD menu tree
appears on the screen. Move the Joy Stick up, down, left &
right to control the OSD functions.
3) Lens adjustment (for Zoom) Joy stick
Adjust the Joy stick left or right to control between TELE &
WIDE, Focus is automatically matched without any adjustment.
7
CAMERA INSTALLATION
COMPATIBILITY
“A” type Box
“B” type Box
CVCTPEXT
CVCTPLATE
[CVCTPLATE Hole Description]
Hole 1 : CVCTPEXT
Hole 2 : Electrical Box “B” type
Hole 3 : Electrical Box “A” type
8
CAMERA INSTALLATION
COMPATIBILITY
BCP
( USING
)
7246WMT
CVCTPEXT
CVCTPLATE
BCP (Direct connection )
9
FEATURES
FOCUS FREE
With 3.7~10mm FOCUS FREE Auto Iris Motorized Zoom Lens,
Focus can be automatically set up by adjusting zoom position.
No more trips back to the installation to re-focus the camera.
Reduces installation time and service calls.
High Resolution
Horizontal resolution of 550 TV lines is achieved by using a
SONY Super-HAD CCD with 410,000 pixels, and a custom DSP
yielding pictures with a high S/N ratio..
DAY/NIGHT
The camera can show color pictures in all lighting conditions.
Or you can have it automatically switch to a B/W in low light
conditions
S-WDR (Speco WDR)
This is Digital -WDR feature which enables to obtain clear and high
quality pictures even in strong backlight condition.
S-DNR (Speco DNR)
This can remove image noise efficiently showing clean images in
low light conditions.
SLC (Speco BLC)
When the image is in front of strong background lighting,
your camera allows you to get a clear image.
10
FEATURES
HLC (High Light Compensation)
This function reverses bright spots in the picture (such as headlights).
It enables the entire system to do a better job of resolving and
displaying grayscale information such as a license plate.
FREEZE
This function freezes the current scene for detailed viewing.
PRIVACY
It also has the ability to mask up to 8 areas of the picture where
Viewing is not desired. Each zone can be independently
programmed via the OSD
OSD
All camera functions are menu driven for easy use.
MIRROR
Picture can be reversed vertically or horizontally.
D-ZOOM
Digital zooming up to 32X.
11
OSD MENU TREE
LENS
◆ DC
EXPOSURE
SLC
◆ SHUTTER ◆ AGC ◆ SLC
◆ S-WDR ◆ RETURN
HLC
WHITE BALANCE
◆ ATW ◆ AWB ◆ AWC-SET ◆ MANUAL ◆ INDOOR ◆ OUTDOOR
DAY / NIGHT
◆ COLOR ◆ AUTO ◆ EXT ◆ B/W
S-DNR
◆ ON ◆ OFF
SPECIAL
◆ CAM TITLE ◆ D-EFFECT ◆ MOTION ◆ PRIVACY ◆ RETURN / END
FREEZE
MIRROR
D-ZOOM
GAMMA
NEG.IMAGE
ADJUST
◆ SHARPNESS ◆ BLUE ◆ RED ◆ RETURN / END
RESET
◆ FACTORY ◆ RETURN / END
EXIT
12
OSD MENU DETAILS
1. EXPOSURE
[OPTION : SHUTTER / AGC / SLC / S-WDR / RETURN]
- SHUTTER
1/60, FLK, 1/250, 1/500, 1/2000, 1/5000, 1/10000, 1/100000
- AGC (Low / Middle / High)
Adjusts value of AGC gain and increases the GAIN level to brighten the
picture. (noise / distortion may develop)
- SLC
* SLC : Back Light Compensation * HLC : High Light Compensation
- S-WDR (Digital Wide Dynamic Range)
To distinguish a subject in both bright and dark areas.
* INDOOR : Activate S-WDR for Indoor use.
* OUTDOOR : Activate S-WDR for Outdoor use.
2. WHITE BALANCE
[OPTIONS : ATW / AWB / AWC SET / MANUAL / INDOOR / OUTDOOR]
- ATW
Auto Tracking White Balance when the color temp in 1800°K~10500°K.
- AWB
Automatically adjust White Balance to your specific conditions.
- AWC SET
Set while pointing the camera towards a sheet of white paper.
- MANUAL
It allows you to increase or decrease the red or blue factor on screen.
- INDOOR
Select this when the color temp. is 4500°K~ 8500°K.
- OUTDOOR
Select this when the color temp. is 1800°K ~10500°K
13
OSD MENU DETAILS
3. DAY / NIGHT
[OPTION : COLOR / BW / AUTO]
- COLOR : Full time color mode
- BW : Full time black & white mode
- AUTO: Automatically detect color or black/white
* DELAY : Set Delay time to switch Color to B/W.
* S-LEVEL : Set Start Level of luminance that you define.
* E-LEVEL : Set End Level of luminance that you define .
*** Only certified technicians should be allowed to this feature.
4. S-DNR
[OPTION : ON / OFF]
- Reduces noise/distortion on the screen.
Increasing the DNR level reduces noise but may introduce video artifacts.
DNR is deactivated if AGC is turned off.
5. SPECIAL - CAM TITLE
[OPTION : ON / OFF]
- Display a name and/or number on the monitor.
14
OSD MENU DETAILS
6. SPECIAL – D-EFFECT
[OPTION : FREEZE / MIRROR / D-ZOOM / GAMMA / NEG.IMAGE]
- FREEZE: Freezes the current scene for detailed viewing.
- MIRROR – ROTATE, V-FLIP, MIRROR
- D-ZOOM : Digital zoom of 1 ~32X.
- GAMMA : 0.45 is fixed. Do not adjust it unless certified technician.
- NET. IMAGE : Change colors off like film.
7.SPECIAL - MOTION
[OPTION : ON / OFF]
- To transmit a alert signal when it detects motion of an object on the
screen. 4 Areas can be selectable.
8. SPECIAL - PRIVACY
[OPTION : ON / OFF]
- Mask up to 8 areas of the screen
9. ADJUST
[OPTION : SHARPNESS / BLUE / RED ]
- Adjust sharpness / RED and BLUE characteristics on the picture.
10. RESET
- Restore all factory default settings.
15
TROUBLESHOOTING
If you have trouble operating your camera, refer to the following
Problem
Solution
Nothing appears on
the screen.
● Check that the power cord and line connection
between the camera and monitor are correct
● Check that you have properly connected VIDEO
cable to the camera VIDEO output jack.
The image on the
screen is dim.
● Is the lens stained with dirt? Clean your lens with
soft, clean cloth.
● Set the monitor for the proper conditions.
● If the camera is exposed to too strong light
change the camera position.
● Adjust the lens’ focus.
The image on the
screen is dark.
● Adjust the contrast feature of the monitor.
● If you have an intermediate device, set the
75Ω/Hi-z properly.
The camera is not
● Check that you have properly connected
working properly,
and
the camera to an appropriate power source.
the surface of the
camera is hot.
MOTION DETECTION
function is not active.
● Have you set ‘MOTION DET.’ menu to off?
● Have you set ‘MD LEVEL’ to too low?
● Have you set ‘MD AREA’ properly
16
TROUBLESHOOTING
Problem
Solution
The color of the
picture is not
proper.
● Check that you have properly set the
‘ WHITE BALANCE ’ menu
The image on the
screen flickers.
● Is the camera facing to direct sunlight or fluorescent
lighting? Change the camera position.
17
LED PATTERN
3.7-10mm FF lens
18 Mini IR LEDs (80’ Range)
18
SPECIFICATIONS
ITEM
VLB11SCSFF
12VDC Only
Power Source
Power Consumption
Image Sensor
Total Pixels
600mA (DC)
1/3”, SONY SUPER HAD CCD, 410,000 pixels
811(H) x 508(V) , 1/3” CCD
768(H) x 494(V) , 1/3” CCD
Focus Free Lens 3.7~10mm
1 : 1.3 ~2.0
Effective Pixels
LENS TYPE
Maximum Aperture Ratio
Scanning System
2 : 1 Interlaced 525 Lines / 60 Fields / 30 Frames
Synchronization
Internal
Video Output
1.0V [p-p] Composite, 75Ω
550 TV Line
Resolution
Gain Control
AGC-L, AGC-M, AGC-H, OFF selectable
1/60 ~ 1/200,000 sec
Electric Shutter Speed
DAY / NIGHT
COLOR / AUTO / BW
COLOR TEMP (White Balance)
Min. Illumination
ATW / AWB / AWC-SET / MANUAL / INDOOR / OUTDOOR
0.3 LUX (F 1.2), 0.00LUX (LED ON)
52dB (Weight On)
S/N ( Y signal)
SPECO DNR
ON / OFF
Motion Detection
On Screen Display ( O.S.D )
PRIVACY Function
Operational Temperature
Operational Humidity
ON / OFF (4 Programmable Zone)
Built - in
ON / OFF (8 Programmable Zone)
-29℃ ~ +50℃ ( - 20℉ ~122℉)
30% ~90% RH
19
DIMENSIONS
* FRONT VIEW
* SIDE VIEW
20
WARRANTY
21
MEMO
MEMO
200 New Highway
Amityville, NY 11701
631-957-8700
VER. 090706
This manual is based on the date as shown in the right and specifications are subject
to Change without notice for quality improvement.
|